Dashboard Regions Weather Stations Radar Alerts Glossary
Contact About
Log In

Register for an account and never miss a forecast again!

Register

Avalanche Forecast

Archived

Dec 20th, 2018–Dec 21st, 2018

Alpine
Natural avalanches possible, human triggered probable.
Treeline
Natural avalanches possible, human triggered probable.
Below Treeline
Natural avalanches unlikely, human triggered possible.
Alpine
Natural avalanches possible, human triggered probable.
Treeline
Natural avalanches possible, human triggered probable.
Below Treeline
Natural avalanches unlikely, human triggered possible.

Regions

.

Avalanche conditions remain dangerous, especially on wind loaded slopes at mid and upper elevations. You can still trigger surprizing avalanches that break widely across terrain features. Stick to lower angled slopes in sheltered areas away from overhead hazard.

Discussion

Snow and Avalanche Discussion

A weak and scary snowpack structure exists throughout the East Cascades. Buried surface hoar and/or near surface facets buried on December 9th are the culprit for several recent avalanches in the Washington Pass area. This weak layer is even blended with basal facets and depth hoar in areas further east and/or at upper elevations. The snowpack needs time to adjust to the heavy load of recent snow.

Snowpack Discussion

Regional Synopsis: December 19, 2018

Why has the avalanche danger been so high for so long? Two reasons: A very active and wet weather pattern combined with a widespread persistent weak layer.

For perspective, the approximate snow totals from 12/9-12/19 are:

  • Mt Baker: 102”

  • Washington Pass: 55”

  • Stevens Pass: 76” mid-mountain

  • Snoqualmie Pass: 68” mid-mountain

  • Crystal Mountain 70” Green Valley

  • Paradise: 78”

  • Mt Hood Meadows: 44” mid-mountain

  • Olympics: 48”

In many areas, a layer of buried surface hoar and/or weak sugary facets was buried on December 9th. This layer has been the cause of numerous natural, explosive, and skier triggered avalanches. As this layer gets deeper it gets harder to assess. In short, the scenario is tricky and getting more dangerous by the day.

Higher snowfall totals along the Hwy 542 corridor/Mt Baker area have driven several avalanche cycles during this period. Loading from recent storms has been more incremental to the east and south of the Mt. Baker area, so we have not yet experienced a widespread cycle in other areas.

When will we reach the breaking point? It’s hard to say. What we do know is we have a deep weak layer, reports of very large explosives triggered slides at Mission Ridge and Crystal Mountain, and more storms on the way.

Be patient and continue to stick to lower angle slopes with nothing above you.  This is a good time to avoid areas where avalanches can start, run, and stop.

We’d like to thank all of you who have sent NWAC your observations. If you are out in the mountains, let us know what you see.

Problems

Wind Slabs

Wind Slab avalanches are the release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.

Persistent Slabs

Persistent Slab avalanches are the release of a cohesive layer of snow (a slab) in the middle to upper snowpack, when the bond to an underlying persistent weak layer breaks. Persistent layers include: surface hoar, depth hoar, near-surface facets, or faceted snow. Persistent weak layers can continue to produce avalanches for days, weeks or even months, making them especially dangerous and tricky. As additional snow and wind events build a thicker slab on top of the persistent weak layer, this avalanche problem may develop into a Deep Persistent Slab.