Avalanche Forecast
Issued: Apr 12th, 2018 11:01AM
The alpine rating is , the treeline rating is , and the below treeline rating is Known problems include Wind Slabs, Storm Slabs and Loose Wet.
NWAC,
Northwest Avalanche Center
Additional precipitation Friday will maintain avalanche conditions in the Mt Hood area. Avalanche problems will vary by elevation during the day. Avoid open slopes greater than 35 degrees at all elevations as conditions continue to grow and change.
Summary
Detailed Forecast
Expect wind and storms slabs formed Thursday to continue to grow Friday as additional snow and wind impacts the Mt Hood area. Use visual clues such as blowing snow, drifts, and fresh cornices to identify and avoid steep wind loaded slopes. You are most likely to trigger a wind slab below cornices, on convex roll overs, or on cross-loaded features.
As snow continues to accumulate, you may be able to trigger storm slab avalanches near treeline. You are most likely to trigger storm slabs on unsupported slopes, near convex rollovers, and in very steep terrain.
At lower elevations, rain will develop wet surface snow conditions. If you see new rollerballs, fan shaped avalanche debris, or experience periods of intense rain, stay off of slopes greater than 35 degrees. Loose wet avalanches can entrain additional snow allowing them to grow large. Use caution if you travel in areas where loose wet avalanches may carry you into or off of terrain with higher consequences.
Watch for other spring hazards such as recent cornices along ridges, open glide cracks and opening creeks.
Snowpack Discussion
In general 6-12 inches (15-30cm) of new snow fell in the Mt Hood area Wednesday afternoon into Thursday. Moderate to strong south to west winds easily transported the new snow, forming new wind slabs near and above treeline on a variety of aspects. This most recent round of precipitation fell on a new melt-freeze crust (4/11) formed during warm weather earlier this week. Observations demonstrate the new crust is strong and supportable.
Reports indicate that the snowpack consist of various layers of melt –freeze crusts, refrozen snow, and strong rounds. This has resulted in a generally strong snowpack without any significant layers of concern.
Observations
Mt Hood Meadows ski patrol reported wind slabs ranging from 8 to 12 inches (20-30cm). Wind and storm slabs were reactive during avalanche control work Thursday morning. The most recent melt-freeze crust was reported as strong and supportable.
Problems
Wind Slabs
Release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.
Wind Slabs form in specific areas, and are confined to lee and cross-loaded terrain features. They can be avoided by sticking to sheltered or wind-scoured areas..
Wind Slab avalanche. Winds blew from left to right. The area above the ridge has been scoured, and the snow drifted into a wind slab on the slope below.
Wind slabs can take up to a week to stabilize. They are confined to lee and cross-loaded terrain features and can be avoided by sticking to sheltered or wind scoured areas.
Aspects: All aspects.
Elevations: Alpine, Treeline.
Likelihood
Expected Size
Storm Slabs
Release of a soft cohesive layer (a slab) of new snow that breaks within the storm snow or on the old snow surface. Storm-slab problems typically last between a few hours and few days. Storm-slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.
You can reduce your risk from Storm Slabs by waiting a day or two after a storm before venturing into steep terrain. Storm slabs are most dangerous on slopes with terrain traps, such as timber, gullies, over cliffs, or terrain features that make it difficult for a rider to escape off the side.
Storm slabs usually stabilize within a few days, and release at or below the trigger point. They exist throughout the terrain, and can be avoided by waiting for the storm snow to stabilize.
Aspects: All aspects.
Elevations: Alpine, Treeline.
Likelihood
Expected Size
Loose Wet
Release of wet unconsolidated snow or slush. These avalanches typically occur within layers of wet snow near the surface of the snowpack, but they may quickly gouge into lower snowpack layers. Like Loose Dry avalanches, they start at a point and entrain snow as they move downhill, forming a fan-shaped avalanche. They generally move slowly, but can contain enough mass to cause significant damage to trees, cars or buildings. Other names for loose-wet avalanches include point-release avalanches or sluffs. Loose Wet avalanches can trigger slab avalanches that break into deeper snow layers.
Travel when the snow surface is colder and stronger. Plan your trips to avoid crossing on or under very steep slopes in the afternoon. Move to colder, shadier slopes once the snow surface turns slushly. Avoid steep, sunlit slopes above terrain traps, cliffs areas and long sustained steep pitches.
Several loose wet avalanches, and lots of pinwheels and roller balls.
Loose wet avalanches occur where water is running through the snowpack, and release at or below the trigger point. Avoid terrain traps such as cliffs, gullies, or tree wells. Exit avalanche terrain when you see pinwheels, roller balls, a slushy surface, or during rain-on-snow events.
Elevations: Below Treeline.
Likelihood
Expected Size
Valid until: Apr 13th, 2018 11:01AM
