Avalanche Forecast
Issued: Feb 22nd, 2020 10:00AM
The alpine rating is , the treeline rating is , and the below treeline rating is Known problems include Wind Slabs and Storm Slabs.
NWAC,
Northwest Avalanche Center
Strong winds and heavy snow will create dangerous avalanche conditions on Sunday. Expect the avalanche danger to increase throughout the day. You could trigger an avalanche on lee slopes steeper than 35 degrees where you find wind deposited snow building fresh wind slabs. In sheltered areas watch for rapid snow accumulation as a sign that you could trigger storm slabs by the afternoon.
Summary
Snowpack Discussion
February 20, 2020 (The regional synopsis is updated every Thursday @ 6 pm)
Intermittent Storms
January’s non-stop pattern of storms extended into the first week of February. Since then, we’ve transitioned to more intermittent storms with notable stretches of high pressure and dry weather. We now see more variability through the region in the snowpack layering and avalanche conditions than in January.
Significant periods of calm weather in February have allowed avalanche danger to decrease between storms. During the clear periods, strengthening late winter sun and gradual warming has brought some loose wet avalanche cycles to sunny slopes. Even so, from February 1st-20th there were 10 days when one or more zones were forecasted at all Low danger. In comparison, the month of January had zero days with any zone forecasted at all Low avalanche danger.
Surface hoar near Snoqualmie Pass. February 19th. Photo: Ely Gerbin
Looking Forward
As we look forward, there are a number of considerations that are pertinent to most zones. The pattern of storms separated by clear periods may form new weak layers and interfaces to monitor. Many zones hold variable surfaces that warrant consideration as a travel hazard. In the Mt Hood Meadows area, two fatalities were related to falls on slick surfaces over President’s Day weekend. Another important consideration is the cornice growth that occurred in the past month from predominantly west winds. Very large cornices loom on ridges in most zones, except for possibly the Olympic Mountains. Future warming could be the added ingredient needed for cornices to fall. A close call with a cornice-triggered avalanche near White Pass on February 12th is a reminder of the potential hazard that cornices can pose.
A party of three triggered this avalanche from below on a southeast aspect at 5400ft near Skyline Lake, Stevens Pass on February 16th. Two members of the party were fully buried and one was partially buried. The party self-rescued and no injuries were sustained. Photo: Dustin Riggs
Weak Layers
So far this season, we’ve had limited persistent weak layers to deal with. February’s periods of calm weather developed a couple of weak layers and problematic interfaces that later got buried in the snowpack. On a whole, weak layers have been short-lived and have generally resolved within a couple of days of being buried. While the following weak layers are no longer major concerns, some readers may want a more in-depth understanding of them before venturing into the mountains.
In the Stevens Pass and East Central zones, the February 4th interface consisted of a thin layer of small (0.5-1.0mm) facets sitting on the stout February 1st melt forms (crust). The crust was widespread on all aspects up to at least 7500ft and the facets were most prominent on the northern half of the compass (west through north through east aspects). A major storm and avalanche cycle February 4th-7th totaled over 60 inches of snow. The February 4th interface was responsible for widespread avalanching including slides up to size D3 at most elevations. As direct action avalanches subsided, the February 4th interface was deeply buried and didn’t produce further triggered avalanches. Interestingly, as recent as February 18th, this interface was found in a profile and produced some mixed and head-scratching test results. While this interface is not a concern for triggered avalanches, you may still be able to find it 4-6 feet below the surface, especially on sheltered, shaded slopes at upper elevations.
A profile from 6460ft on a northeast aspect in the Chiwaukum Range on February 18th shows the February 4th layer. Small column tests produced sudden planar results while a Propagation Saw Test did not indicate propagation.
A more elusive and problematic layer for triggered avalanches was the February 13th interface. This was also most prominent in the Stevens Pass and East Central zones in addition areas of the West Central and Snoqualmie Pass zones. At Stevens Pass a combination of large (2.0-4.0mm) surface hoar and small (0.5mm) near-surface facets developed on a variety of surfaces and were buried on the 13th. The weak layer was most problematic on east through south aspects between 4,500-6,000ft, where the grains were preserved as they rested on a thin crust. It seemed that outside of this aspect and elevation range either 1) the weak grains did not persist enough to be triggered by travelers or 2) the underlying layer, or bed surface, wasn’t hard enough for the weak layer to be reactive. A number of parties reported natural and triggered avalanches on southeast aspects during the storm cycle on Presidents Day weekend. This included a party of three that were uninjured after all being caught, with two full-burials, in a surprising avalanche near Skyline Lake on the 17th. As of February 20th, the interface is 1-3 feet below the surface and has become difficult to trigger. The February 13th interface is still visible in the snowpack and we continue to monitor it. It will likely become inactive before the end of the month.
In summary, February has been a great time to explore the mountains and enjoy the longer days for recreating in this season’s robust snowpack. Though, not without complexity and variability. Continue to monitor changing conditions and check the daily avalanche forecasts for the most up to date information.
Problems
Wind Slabs
Very strong winds will rapidly transport new snow and quickly build fresh wind slabs. With strong winds and heavy snow in the forecast, expect the size of wind slabs to increase during the day as well as the likelihood of triggering a wind slab. Look for evidence of wind transported snow. Active blowing snow, cornice development, and stiff or textured snow surfaces are all signs that you could trigger a wind slab. Where you see these clues avoid travel on lee slopes steeper than 35 degrees. Choose ridges, scoured slopes, and low angle terrain to stay safe. Wind slabs will be most likely on slopes near and above treeline, but winds are forecast to be strong enough that wind slabs may begin to form below treeline as well.
Release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.
Wind Slabs form in specific areas, and are confined to lee and cross-loaded terrain features. They can be avoided by sticking to sheltered or wind-scoured areas..
Wind Slab avalanche. Winds blew from left to right. The area above the ridge has been scoured, and the snow drifted into a wind slab on the slope below.
Wind slabs can take up to a week to stabilize. They are confined to lee and cross-loaded terrain features and can be avoided by sticking to sheltered or wind scoured areas.
Aspects: All aspects.
Elevations: Alpine, Treeline.
Likelihood
Expected Size
Storm Slabs
Look for signs that you could trigger a storm slab avalanche such as strong snow over weak snow, cracks shooting through the snow, and natural avalanches. Where you see these signs, avoid slopes steeper than 35 degrees as well as unsupported slopes such as those above cliffs and creeks.
There is some uncertainty about how rapidly avalanche danger will increase in wind-sheltered areas on Sunday. Not much snow accumulation is expected overnight Saturday, so avalanche danger may start off lower than considerable, but as snow stacks up Sunday the possibility of triggering a storm slab will increase. Remember that triggering a storm slab is most likely during times of heavy snowfall, so keep an eye on changing conditions throughout the day.
Release of a soft cohesive layer (a slab) of new snow that breaks within the storm snow or on the old snow surface. Storm-slab problems typically last between a few hours and few days. Storm-slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.
You can reduce your risk from Storm Slabs by waiting a day or two after a storm before venturing into steep terrain. Storm slabs are most dangerous on slopes with terrain traps, such as timber, gullies, over cliffs, or terrain features that make it difficult for a rider to escape off the side.
Storm slabs usually stabilize within a few days, and release at or below the trigger point. They exist throughout the terrain, and can be avoided by waiting for the storm snow to stabilize.
Elevations: Below Treeline.
Likelihood
Expected Size
Valid until: Feb 23rd, 2020 10:00AM
