Avalanche Forecast

Issued: Feb 22nd, 2020 10:00AM

The alpine rating is considerable, the treeline rating is considerable, and the below treeline rating is considerable. Known problems include Wind Slabs and Storm Slabs.

Northwest Avalanche Center NWAC, Northwest Avalanche Center

Email

Stormy conditions could make things dangerous around the West South zone Sunday as snow and wind dramatically increase the avalanche hazard during the day. In some areas, the new snow could fall on a very weak surface allowing avalanches to trigger easily and fail in surprising ways. When the snow begins to pile up, it’s time to dial it down and steer around open slopes greater than 30 degrees.

Summary

Discussion

This forecast is a bit tricky. A few pieces present particular difficulties. The first is timing. This storm mainly occurs during the day Sunday leading to increasing avalanche danger in all areas. However, in some areas, where more snow falls, the avalanche danger could increase rapidly. For others, the avalanche danger may not peak until late in the afternoon. Either way, don’t expect slopes that seem safe in the morning to feel that way later in the day. Choose trip plans with plenty of options to adjust to changing conditions and easily navigate around avalanche terrain if conditions are spicier than you anticipate. 

The second piece is the presence of very weak snow surfaces in some areas. Observations found surface hoar, near-surface facets, old powder, and breakable crusts around the West South and were even reported well below treeline. A little sunshine and some wind may have helped breakdown some of these weak surfaces Saturday, but they appear to have survived in many areas. Once these snow grains get buried, it will be difficult if not impossible to predict their locations. On Saturday surface hoar seemed most prevalent on W-N-NE aspects near and below treeline. Avalanches failing on surface hoar and facets could act in surprising ways including remotely triggering and failing low on the slope. In many places, surface hoar was observed on steep areas low in avalanche paths, well away from what would generally be considered the start zones. 

Surface hoar surviving on the ridgecrest of Crown Point in the Crystal backcountry despite moderate winds Saturday. 6300’ W aspect. Photo: Dallas Glass

Snowpack Discussion

February 20, 2020 (The regional synopsis is updated every Thursday @ 6 pm)

Intermittent Storms

January’s non-stop pattern of storms extended into the first week of February. Since then, we’ve transitioned to more intermittent storms with notable stretches of high pressure and dry weather. We now see more variability through the region in the snowpack layering and avalanche conditions than in January. 

Significant periods of calm weather in February have allowed avalanche danger to decrease between storms. During the clear periods, strengthening late winter sun and gradual warming has brought some loose wet avalanche cycles to sunny slopes. Even so, from February 1st-20th there were 10 days when one or more zones were forecasted at all Low danger. In comparison, the month of January had zero days with any zone forecasted at all Low avalanche danger. 

Surface hoar near Snoqualmie Pass. February 19th. Photo: Ely Gerbin

Looking Forward

As we look forward, there are a number of considerations that are pertinent to most zones. The pattern of storms separated by clear periods may form new weak layers and interfaces to monitor. Many zones hold variable surfaces that warrant consideration as a travel hazard. In the Mt Hood Meadows area, two fatalities were related to falls on slick surfaces over President’s Day weekend. Another important consideration is the cornice growth that occurred in the past month from predominantly west winds. Very large cornices loom on ridges in most zones, except for possibly the Olympic Mountains. Future warming could be the added ingredient needed for cornices to fall. A close call with a cornice-triggered avalanche near White Pass on February 12th is a reminder of the potential hazard that cornices can pose. 

 

A party of three triggered this avalanche from below on a southeast aspect at 5400ft near Skyline Lake, Stevens Pass on February 16th. Two members of the party were fully buried and one was partially buried. The party self-rescued and no injuries were sustained. Photo: Dustin Riggs 

Weak Layers

So far this season, we’ve had limited persistent weak layers to deal with. February’s periods of calm weather developed a couple of weak layers and problematic interfaces that later got buried in the snowpack. On a whole, weak layers have been short-lived and have generally resolved within a couple of days of being buried. While the following weak layers are no longer major concerns, some readers may want a more in-depth understanding of them before venturing into the mountains.

In the Stevens Pass and East Central zones, the February 4th interface consisted of a thin layer of small (0.5-1.0mm) facets sitting on the stout February 1st melt forms (crust). The crust was widespread on all aspects up to at least 7500ft and the facets were most prominent on the northern half of the compass (west through north through east aspects). A major storm and avalanche cycle February 4th-7th totaled over 60 inches of snow. The February 4th interface was responsible for widespread avalanching including slides up to size D3 at most elevations. As direct action avalanches subsided, the February 4th interface was deeply buried and didn’t produce further triggered avalanches. Interestingly, as recent as February 18th, this interface was found in a profile and produced some mixed and head-scratching test results. While this interface is not a concern for triggered avalanches, you may still be able to find it 4-6 feet below the surface, especially on sheltered, shaded slopes at upper elevations.

 

A profile from 6460ft on a northeast aspect in the Chiwaukum Range on February 18th shows the February 4th layer. Small column tests produced sudden planar results while a Propagation Saw Test did not indicate propagation.

A more elusive and problematic layer for triggered avalanches was the February 13th interface. This was also most prominent in the Stevens Pass and East Central zones in addition areas of the West Central and Snoqualmie Pass zones. At Stevens Pass a combination of large (2.0-4.0mm) surface hoar and small (0.5mm) near-surface facets developed on a variety of surfaces and were buried on the 13th. The weak layer was most problematic on east through south aspects between 4,500-6,000ft, where the grains were preserved as they rested on a thin crust. It seemed that outside of this aspect and elevation range either 1) the weak grains did not persist enough to be triggered by travelers or 2) the underlying layer, or bed surface, wasn’t hard enough for the weak layer to be reactive. A number of parties reported natural and triggered avalanches on southeast aspects during the storm cycle on Presidents Day weekend. This included a party of three that were uninjured after all being caught, with two full-burials, in a surprising avalanche near Skyline Lake on the 17th. As of February 20th, the interface is 1-3 feet below the surface and has become difficult to trigger. The February 13th interface is still visible in the snowpack and we continue to monitor it. It will likely become inactive before the end of the month.

In summary, February has been a great time to explore the mountains and enjoy the longer days for recreating in this season’s robust snowpack. Though, not without complexity and variability. Continue to monitor changing conditions and check the daily avalanche forecasts for the most up to date information. 

Problems

Wind Slabs

An icon showing Wind Slabs

It looks like conditions get windy in the West South Sunday. Blowing snow may be the easiest way to see which slopes could be forming winds slabs. Other clues such as drifts behind objects and textured snow surfaces could point out wind loaded areas. With such strong winds, slabs may form on any exposed feature and along the sides of mid-slope gullies. Steer around slopes greater than 30 degrees if you suspect wind affected snow. Wind slabs should grow larger as you ascend in elevation and more snow blows around throughout the day.

Release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.

 

Wind Slabs form in specific areas, and are confined to lee and cross-loaded terrain features. They can be avoided by sticking to sheltered or wind-scoured areas..

 

Wind Slab avalanche. Winds blew from left to right. The area above the ridge has been scoured, and the snow drifted into a wind slab on the slope below.

 

Wind slabs can take up to a week to stabilize. They are confined to lee and cross-loaded terrain features and can be avoided by sticking to sheltered or wind scoured areas.

Aspects: All aspects.

Elevations: All elevations.

Likelihood

Likely

Expected Size

1 - 1

Storm Slabs

An icon showing Storm Slabs

You aren’t likely to bump into these right off the bat in the morning. It could take a bit for enough snow to accumulate to pose a storm slab problem. As a result, you’ll need to monitor changing conditions. When you see more than 6” of new snow, small slope tests produce avalanches, or you see cracking in the storm snow, it’s time to dial it back. Steer around open slopes greater than 30 degrees if you suspect storm slabs are becoming reactive. If these slabs form over surface hoar and/or facets, you could trigger an avalanche on small slopes, and away from larger more traditional avalanche start zones.

Release of a soft cohesive layer (a slab) of new snow that breaks within the storm snow or on the old snow surface. Storm-slab problems typically last between a few hours and few days. Storm-slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.

 

You can reduce your risk from Storm Slabs by waiting a day or two after a storm before venturing into steep terrain. Storm slabs are most dangerous on slopes with terrain traps, such as timber, gullies, over cliffs, or terrain features that make it difficult for a rider to escape off the side.

 

Storm slabs usually stabilize within a few days, and release at or below the trigger point. They exist throughout the terrain, and can be avoided by waiting for the storm snow to stabilize.

Elevations: Treeline, Below Treeline.

Likelihood

Likely

Expected Size

1 - 1

Valid until: Feb 23rd, 2020 10:00AM