Avalanche Forecast

Issued: Feb 22nd, 2019 10:11AM

The alpine rating is considerable, the treeline rating is considerable, and the below treeline rating is moderate. Known problems include Wind Slabs and Persistent Slabs.

Northwest Avalanche Center NWAC, Northwest Avalanche Center

It’s the areas where the wind affected the snow that will cause you the most problems on Saturday. Evidence of wind slabs may be hiding under a few inches of soft snow, so keep your eyes open. Look for sharp cornices, large snow drifts, or the snow blown out of the trees to clue you into nearby wind slabs. In these areas, steer away from open slopes greater than 35 degrees.

Summary

Discussion

Snow and Avalanche Discussion

The story from Friday around the West North zone was the winds. The weather station at Mt Baker ski area recorded 20 hrs of moderate or stronger average wind speeds. That’s plenty fast to efficiently move snow. Just because you are out of the wind affected areas doesn’t mean you're fully in the clear. With all the new snow, you may encounter a rogue storm slab or loose avalanche in sheltered areas. Be leery of very steep slopes and any areas where small avalanches could bury you deeply such as gullies.

The snow from Friday will continue to add to the slab over a layer of buried surface hoar, facets, and/or crusts. At this point, this weak layer is likely nearing 10-12” deep. So far, we have not heard of any avalanches on this layer. Will that change? It’s tough to say. As the snow continues to stack up, keep this layer on your mind. You may encounter it in some more unusual locations such as lower and mid-elevation areas.

Even though there have not been any recent avalanches reported in the West North zone, other areas in the Washington Cascades are still suffering from a similar persistent slab problem. There have been three recent very large avalanches reported in the Crystal area. While that may seem like a long way away, they serve as a reminder to not totally let the persistent weak layer drop from your radar.

Snowpack Discussion

February 19th, 2019

Recap

We’re now over a week out from a major winter storm and avalanche cycle that left a string of school cancellations and avalanche near misses in its wake. As with snowfall amounts, the avalanche cycles have been similar, but not identical in all regions. The further we’re getting from the peak of the cycle, the more variation in avalanche conditions we’re seeing between regions and even within individual zones. Variable snow totals from storms this week are further adding to the range of conditions you will encounter. In some places, these storms may add stress to existing weak layers.

In the days after the natural cycle, it was obvious that you could trigger an avalanche. Large crowns were visible and you could feel and hear collapses in many zones. Managing your risk was easy. Avoid avalanche terrain. Since the natural avalanche cycle quieted down, the main concern for avalanches has focussed on the February 8th facets in regions where the weak layer is problematic.

A natural persistent slab (D2) on a north aspect at 4200 ft low in Glacier Creek drainage (Hwy 542). 02/13/19 Lee Lazzara Photo

Variability and Mixed Messages

As the time moves on and the snowpack structure changes, we’re seeing the potential for triggering avalanches change as well. The February 8th layer is rounding (strengthening) and the likelihood of triggering an avalanche on it is decreasing. So much so that the problem is trending to unlikely in some regions. Unfortunately, the consequences (size and destructive potential) remain the same if you do trigger an avalanche on this layer.

These conditions are commonly described as "low probability - high consequence" scenarios. Under these circumstances, common clues may paint a conflicting picture and snowpack tests become even more difficult to interpret (snowpack tests often don’t give us a clear “go or no-go” answer, if such a thing exists).

Q: How do we manage our risk when observations are contradictory and difficult to interpret?

A: When avalanche conditions are complicated, defer to less consequential and simpler. Prioritize obvious clues, like recent avalanches, shooting cracks, or collapses. Focus on other observations that indicate a potential to trigger avalanches. Snowpack tests are just one piece of the decision-making puzzle. Lean on them as reasons to reduce your groups' exposure to avalanche terrain. Don’t use them to justify traveling in more consequential terrain.

A natural persistent slab avalanche (D2), likely occurred on 2/12 on southwest through southeast aspects of Windy Mountain at 5,400ft in the Tye River drainage. Photo: Dan Veenhuizen.

Case Study

On the 17th I dug a profile, east of Stevens Pass on a north-northeast aspect at 4,127ft. I found the February 8th facets (0.5-1.5mm) rounding and buried 59cm from the surface. After much investigation, I found the following results at the February 8th interface: CTH (SP), ECTN28, PST 45/100 (END), 5 yellow flags (structural indicators). Later that day, about 2000 linear feet away from the profile site at the same elevation and slightly different aspect, we experienced a massive rumbling collapse.

All this crypto snow-speak means that some of the observations I made indicated that triggering an avalanche was likely, but some did not. Depending on your interpretation, some results could be argued either way. Confusing, right?

With all of this data in my field book, it was the collapse that stuck out. It was enough evidence for me to avoid slopes steeper than 35 degrees. That was a more obvious answer than all the other data I gathered and it’s the easiest to interpret. Without the collapse, I would have prioritized the test results that indicated I could have triggered a slide.

Problems

Wind Slabs

An icon showing Wind Slabs

The winds on Friday likely reshaped the snow surface in many locations. In doing so, new wind slabs are expected at all elevations. Keep your eyes open for signs of wind transported snow. If the winds die off before the precipitation stops, a few inches of undisturbed snow may hide some of the evidence. Is the snow blown out of the trees? Are there snowdrifts behind trees and rocks? Does the snow feel firm under you as you travel? When you answer yes, wind slabs are likely nearby. If you suspect the wind has loaded the slope, avoid open areas greater than 35 degrees.

Release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.

 

Wind Slabs form in specific areas, and are confined to lee and cross-loaded terrain features. They can be avoided by sticking to sheltered or wind-scoured areas..

 

Wind Slab avalanche. Winds blew from left to right. The area above the ridge has been scoured, and the snow drifted into a wind slab on the slope below.

 

Wind slabs can take up to a week to stabilize. They are confined to lee and cross-loaded terrain features and can be avoided by sticking to sheltered or wind scoured areas.

Aspects: All aspects.

Elevations: All elevations.

Likelihood

Likely

Expected Size

1 - 1

Persistent Slabs

An icon showing Persistent Slabs

The persistent weak layer has been quiet this week. That’s good news and gives us some confidence. However, there are still enough pieces of evidence pointing towards weak snow layers that this problem is still on our minds. You aren’t likely to encounter any obvious signs of instability. The only way to see this problem is to dig in the snow. You may find a layer of facets and/or surface hoar 2-4ft below the snow surface. If you suspect this layer is present, it’s best to simply stay off of large open slopes greater than 35 degrees.

Release of a cohesive layer of soft to hard snow (a slab) in the middle to upper snowpack, when the bond to an underlying persistent weak layer breaks. Persistent layers include: surface hoar, depth hoar, near-surface facets, or faceted snow. Persistent weak layers can continue to produce avalanches for days, weeks or even months, making them especially dangerous and tricky. As additional snow and wind events build a thicker slab on top of the persistent weak layer, this avalanche problem may develop into a Deep Persistent Slabs.

 

The best ways to manage the risk from Persistent Slabs is to make conservative terrain choices. They can be triggered by light loads and weeks after the last storm. The slabs often propagate in surprising and unpredictable ways. This makes this problem difficult to predict and manage and requires a wide safety buffer to handle the uncertainty.

 

This Persistent Slab was triggered remotely, failed on a layer of faceted snow in the middle of the snowpack, and crossed several terrain features.

Persistent slabs can be triggered by light loads and weeks after the last storm. You can trigger them remotely and they often propagate across and beyond terrain features that would otherwise confine wind and storm slabs. Give yourself a wide safety buffer to handle the uncertainty.

Aspects: All aspects.

Elevations: All elevations.

Likelihood

Possible

Expected Size

1 - 1

Valid until: Feb 23rd, 2019 10:11AM