Avalanche Forecast

Issued: Feb 2nd, 2019 10:00AM

The alpine rating is considerable, the treeline rating is moderate, and the below treeline rating is low. Known problems include Storm Slabs.

Northwest Avalanche Center NWAC, Northwest Avalanche Center

Dangerous conditions exist above treeline where significant snowfall accumulated over the past two days. Fresh storms slabs become easier to trigger as you gain elevation. Choose conservative terrain while the snowpack adjusts to the heavy load of new snow.

Summary

Discussion

Snow and Avalanche Discussion

The Mt. Baker area received over 3in of water since late Thursday night with snow levels fluctuating between 3500-5000ft. A mix of rain and very wet snow fell below 4000ft. The Heather Meadows weather station (4200ft) recorded 18in of new snow. Snow totals increase significantly as you gain elevation with up to 3ft of new snow measured at 5000ft. Expect significant cooling on Sunday with cloudy skies and light snowfall in the afternoon.  

Natural and triggered avalanches were reported in the Mt. Baker area on Saturday. Crowns from natural avalanches that likely ran in the past 24 hours were visible in alpine terrain on the north face of Mount Shuksan. Human-triggered storm slab avalanches occurred Saturday on north and east aspects near and above treeline (the largest of which broke 20in deep and 100ft wide). Small wet loose avalanches occurred on steep slopes near and below treeline. Overall, the new snow appears to be bonding well to the old snow surface. However, density breaks within the storm snow are reactive and still need time to heal.

Snowpack Discussion

January, 31, 2019

As we turn the corner to February we're coming out of a week-long high pressure ridge and into unsettled weather. The snowpack survived extremely warm temperatures and sunny skies over the week. This break in the weather allowed for avalanche danger to steadily decline in all regions. Stormy weather starting February 1st once again elevated the avalanche danger and brought a round of storm related avalanches.

We’ve heard a variety of stories from backcountry travelers over the past week. There have been reports of extremely firm slopes creating slide-for-life conditions. Others reported perfect spring like snow. Some encountered difficult breakable crust. And, for a lucky few, softer, drier, mid-winter snow has been found. A common thread in most zones is where precipitation falls as snow, it has landed on slick surfaces. It's time to pay attention to the interfaces formed by our recent rounds of precipitation.

A skier triggered storm slab in the recent snow in a steep southeast start zone at 5700ft. Lichtenberg Mtn. Feb 2. Photo: Josh Hirshberg

North-South:

While a high elevation rain event, around January 23rd, formed surface crust in many regions, it’s the constant melt-freeze cycles from the past week, that caused a divergence in the Northerly and Southerly snowpacks.

Near surface facets developed on shaded snow surfaces in many areas. These facets are from near Mt Baker. Photo: Lee Lazzara

North: On shady slopes, things haven’t exactly been soft. The crust formed at the end of the last storm extends to high elevations (Mt. Hood 7000+ft, South Cascades 6500 ft, Passes and Central Cascades 6000 ft. and West-North 5500 ft.). Only areas in the East Cascades seemed to escape the wrath of this breakable crust. Without the help of the sun, shady slopes haven’t been softening even during this period of warm weather. Instead, the surface crust underwent some weakening. Observations found faceting on top of and below this crust. In some locations, this caused the crust to begin to degrade, becoming less supportive. Surface hoar has also been reported from the typical valley bottoms and sheltered terrain near water sources. At low to mid elevations, rain may have melted any weak snow on the surface. Slopes receiving significant dry snow should be suspect for a poor bond at the interface buried around February 1st.

Roller balls and loose wet avalanches on a sunny, southeast slope following the Feb 1st storm Lichtenberg Mtn. Photo: Josh Hirshberg

South: On sunny aspects, the sun drove warming and melting of surface snow. Long, cool, winter nights allowed for the surface to freeze again. This repeating melt-freeze pattern created a thicker, firmer, and more supportable surface. On many days, weak surface snow, such as near surface facets or surface hoar, melted during the day limiting its development. On cooler days, very firm travel conditions were reported. Crusts may provide a poor bond for any snow falling on them. Following the Feb 1st storm, the sun drove a round of small wet loose avalanches and storm slabs on upper elevations slopes that received enough accumulation.

East-West:While we're tracking persistent weak layers (PWL’s), they haven't been the source of avalanches for over a week. It’s not uncommon for our east-side forecast zones to experience lingering PWL's. This season, we’ve also seen several different PWL’s in our western zones. This break in the weather gave the snowpack time to gain strength in all zones.

West: While you may find some weak snow in the upper few inches of the snowpack, the mid and lower snowpack has been found to be quite strong. Firm rounded grains, stout  crust, and strong frozen melt-forms make up the majority of the snowpack at this time.

Southeasterly winds textured surfaces on the east side of Washington Pass on Feb 1-2nd. Photo Matt Primomo

East: The east-side snowpack continues to be highly variable. You may find deep strong snowpacks closer to the crest or you could encounter shallow weak snowpacks areas further east. While there are number of potentially weak interfaces, there are two more common layers we’ve got our eyes on.

  1. January 22nd surface hoar and small facets. You can find these just under the recent storm snow, about a foot down. .

  2. December 26th surface hoar. This layer can be found from 16” to 40” down and is still producing clean, planar shears with tests.

You are most likely to find these layers to be preserved on wind sheltered, shady, and open slopes above 5,500ft. You can find more defined weak layers where snowpack is less than 4 feet deep and variable especially east of Highway 97. Persistent weak layers have been “dormant” or unreactive during the week of high pressure. The latest storm has not been enough to re-activate theses weak layers. We’ll keep tracking them to watch their progression..

The lower eastern slopes and the Columbia River. Snow exists at low elevations, but snowpack depths are shallow. Photo: Matt Primomo

 

Problems

Storm Slabs

An icon showing Storm Slabs

Fresh storm slabs exist near and above treeline. These slabs are the thickest and most dangerous at upper elevations where you can trigger a large avalanche. Be especially careful of wind loaded areas where more reactive slabs may exist. The majority of recent storm slab avalanches failed on density breaks within new snow. Assess these layers, as well the new/old snow interface. Pay attention to changing conditions as you climb higher in the terrain. Watch for recent avalanches on similar slopes you plan to ski and ride, and for shooting cracks and collapses as you travel. Look for sudden changes in snow surface texture and hardness to identify wind-drifted areas of snow. Continue to give the new snow time to stabilize, especially at upper elevations. Avoid large, open, convex slopes 35 degrees and steeper above treeline.

Release of a soft cohesive layer (a slab) of new snow that breaks within the storm snow or on the old snow surface. Storm-slab problems typically last between a few hours and few days. Storm-slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.

 

You can reduce your risk from Storm Slabs by waiting a day or two after a storm before venturing into steep terrain. Storm slabs are most dangerous on slopes with terrain traps, such as timber, gullies, over cliffs, or terrain features that make it difficult for a rider to escape off the side.

 

Storm slabs usually stabilize within a few days, and release at or below the trigger point. They exist throughout the terrain, and can be avoided by waiting for the storm snow to stabilize.

Aspects: All aspects.

Elevations: Alpine, Treeline.

Likelihood

Likely

Expected Size

1 - 1

Valid until: Feb 3rd, 2019 10:00AM