Avalanche Forecast

Issued: Feb 23rd, 2019 10:15AM

The alpine rating is considerable, the treeline rating is moderate, and the below treeline rating is moderate. Known problems include Wind Slabs and Persistent Slabs.

Northwest Avalanche Center NWAC, Northwest Avalanche Center

Upslope flow should favor the East Cascades on Sunday, creating dangerous avalanche conditions. Wind slabs may become sensitive on exposed slopes, persistent slabs are being stressed on shaded aspects, and loose dry avalanches may become common on steep slopes all around. Sunday is not the day to go into big, complex terrain. Choose well supported routes with limited exposure to avalanche terrain.

Summary

Discussion

Snow and Avalanche Discussion

New snow amounts from Friday night/Saturday vary widely across the region. The Salmon la Sac appears to have won that round with 8" of snow and 0.6" of snow water equivalent. More snow is likely to be found at higher elevations in that area. I found about 4" at 4,000ft in Icicle Creek, and Blewett Pass/Mission Ridge came in at just a couple of inches. A fair amount of uncertainty exists with the weather forecasts for Sunday, but in any case the snow should begin to pile up. On Friday, I went into the hills above Number 2 Canyon, finding a poor snowpack structure on northerly aspects in sagebrush country. The large facets near the ground have changed little since my last time in similar terrain about 10 days ago. Slab avalanches remain possible on this weak basal structure, and a recent avalanche was observed in Swakane Canyon on a North aspect at 1,900ft on this same layer (see photo below). On Thursday at Stevens Pass, skiers were able to easily trigger small soft slab avalanches that ran on a recently buried melt freeze crust, which was the new/old snow interface. These were 6” deep, and on Southeast aspects at 5,500ft on Lichtenberg Mountain. This same recently buried crust is likely to be found in the western part of the zone in areas such as the Salmon la Sac, Teanaway, and Icicle. The last reported collapses in the area came from an observer on Tumwater Mountain on the 19th, though a few were reported from Arrowhead in the eastern Hwy 2 corridor on Saturday. 

D2 Persistent Slab avalanche in Swakane Canyon that ran on basal facets near the ground. North at ~1900ft. Unknown when it occurred, perhaps remotely triggered by a skier ascending the rib nearby. Observed on 2/22. Photo: Steven Gnam

Snowpack Discussion

February 19th, 2019

Recap

We’re now over a week out from a major winter storm and avalanche cycle that left a string of school cancellations and avalanche near misses in its wake. As with snowfall amounts, the avalanche cycles have been similar, but not identical in all regions. The further we’re getting from the peak of the cycle, the more variation in avalanche conditions we’re seeing between regions and even within individual zones. Variable snow totals from storms this week are further adding to the range of conditions you will encounter. In some places, these storms may add stress to existing weak layers.

In the days after the natural cycle, it was obvious that you could trigger an avalanche. Large crowns were visible and you could feel and hear collapses in many zones. Managing your risk was easy. Avoid avalanche terrain. Since the natural avalanche cycle quieted down, the main concern for avalanches has focussed on the February 8th facets in regions where the weak layer is problematic.

A natural persistent slab (D2) on a north aspect at 4200 ft low in Glacier Creek drainage (Hwy 542). 02/13/19 Lee Lazzara Photo

Variability and Mixed Messages

As the time moves on and the snowpack structure changes, we’re seeing the potential for triggering avalanches change as well. The February 8th layer is rounding (strengthening) and the likelihood of triggering an avalanche on it is decreasing. So much so that the problem is trending to unlikely in some regions. Unfortunately, the consequences (size and destructive potential) remain the same if you do trigger an avalanche on this layer.

These conditions are commonly described as "low probability - high consequence" scenarios. Under these circumstances, common clues may paint a conflicting picture and snowpack tests become even more difficult to interpret (snowpack tests often don’t give us a clear “go or no-go” answer, if such a thing exists).

Q: How do we manage our risk when observations are contradictory and difficult to interpret?

A: When avalanche conditions are complicated, defer to less consequential and simpler. Prioritize obvious clues, like recent avalanches, shooting cracks, or collapses. Focus on other observations that indicate a potential to trigger avalanches. Snowpack tests are just one piece of the decision-making puzzle. Lean on them as reasons to reduce your groups' exposure to avalanche terrain. Don’t use them to justify traveling in more consequential terrain.

A natural persistent slab avalanche (D2), likely occurred on 2/12 on southwest through southeast aspects of Windy Mountain at 5,400ft in the Tye River drainage. Photo: Dan Veenhuizen.

Case Study

On the 17th I dug a profile, east of Stevens Pass on a north-northeast aspect at 4,127ft. I found the February 8th facets (0.5-1.5mm) rounding and buried 59cm from the surface. After much investigation, I found the following results at the February 8th interface: CTH (SP), ECTN28, PST 45/100 (END), 5 yellow flags (structural indicators). Later that day, about 2000 linear feet away from the profile site at the same elevation and slightly different aspect, we experienced a massive rumbling collapse.

All this crypto snow-speak means that some of the observations I made indicated that triggering an avalanche was likely, but some did not. Depending on your interpretation, some results could be argued either way. Confusing, right?

With all of this data in my field book, it was the collapse that stuck out. It was enough evidence for me to avoid slopes steeper than 35 degrees. That was a more obvious answer than all the other data I gathered and it’s the easiest to interpret. Without the collapse, I would have prioritized the test results that indicated I could have triggered a slide.

Problems

Wind Slabs

An icon showing Wind Slabs

Snowfall and easterly winds should ramp up tonight and continue into Sunday. Most avalanches occur during, or directly after a snowfall event. Be especially cautious if it is "dumping". Winds may create stiffer and deeper drifts and slabs may be resting on weak snow. Places in the alpine, and open, exposed locations where easterly winds speed up may hold larger slabs. If there is enough cohesion within the new snow, slab avalanches may be sensitive, easy to initiate, and they could pack a punch. Besides wind slab within the new snow, this hefty load is sitting on a couple of potentially problematic recently buried layers. These consist of weak, faceted grains on northerly aspects, and melt freeze crusts on southerlies, potentially with facets on the top. Cracking in front of your sled, or ski tips is a good sign to step back, and seek out lower angled and more sheltered terrain. Any slide within the upper layers may step down and create a much larger and destructive deep slab avalanche. Out of the wind zone, the new snow may still be susceptible to easy "sluffing", or loose dry avalanching on steep slopes. These could entrain, and run fairly fast. 

Release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.

 

Wind Slabs form in specific areas, and are confined to lee and cross-loaded terrain features. They can be avoided by sticking to sheltered or wind-scoured areas..

 

Wind Slab avalanche. Winds blew from left to right. The area above the ridge has been scoured, and the snow drifted into a wind slab on the slope below.

 

Wind slabs can take up to a week to stabilize. They are confined to lee and cross-loaded terrain features and can be avoided by sticking to sheltered or wind scoured areas.

Aspects: All aspects.

Elevations: Alpine, Treeline.

Likelihood

Likely

Expected Size

1 - 1

Persistent Slabs

An icon showing Persistent Slabs

Snowfall continues to add weight, stressing these layers. The recent storm cycle may begin to stress deeper weak layers, again. The February 8th facet/crust layer can be found from 1-3 feet beneath the surface, and may be most preserved on northerly aspects. Tests continue to indicate the potential for avalanches to occur on it. The shallower snowpack zones closer to the Columbia River have weaker structure than nearer the crest. Here, you can find a very weak, faceted snowpack on northerly aspects. In this part of the zone, the most dangerous slopes are where you find stiff wind drifts overlying weak, large grained facets. 

Sunday will be more dangerous than Saturday in the entire zone. To hedge your bets, avoid large open slopes 35 degrees and steeper, and minimize your exposure to avalanche terrain. Especially steer clear of steep, unsupported slopes. Stop and re-group in safer terrain, well out from under overhead avalanche paths. Choose conservative up routes and descent options and when dealing with this problem. A handful of sled or ski tracks on a slope doesn't mean that it won't go with the 6th, or 10th person. 

Release of a cohesive layer of soft to hard snow (a slab) in the middle to upper snowpack, when the bond to an underlying persistent weak layer breaks. Persistent layers include: surface hoar, depth hoar, near-surface facets, or faceted snow. Persistent weak layers can continue to produce avalanches for days, weeks or even months, making them especially dangerous and tricky. As additional snow and wind events build a thicker slab on top of the persistent weak layer, this avalanche problem may develop into a Deep Persistent Slabs.

 

The best ways to manage the risk from Persistent Slabs is to make conservative terrain choices. They can be triggered by light loads and weeks after the last storm. The slabs often propagate in surprising and unpredictable ways. This makes this problem difficult to predict and manage and requires a wide safety buffer to handle the uncertainty.

 

This Persistent Slab was triggered remotely, failed on a layer of faceted snow in the middle of the snowpack, and crossed several terrain features.

Persistent slabs can be triggered by light loads and weeks after the last storm. You can trigger them remotely and they often propagate across and beyond terrain features that would otherwise confine wind and storm slabs. Give yourself a wide safety buffer to handle the uncertainty.

Aspects: All aspects.

Elevations: All elevations.

Likelihood

Possible

Expected Size

1 - 2

Valid until: Feb 24th, 2019 10:15AM