Avalanche Forecast
Regions: Cascades - North East.
Upslope flow should allow snowfall to continue into Sunday, creating heightened avalanche conditions. Wind slabs may become sensitive on exposed slopes, persistent slabs may become stressed on shaded aspects, and loose dry avalanches may become common on steep slopes all around. Choose well supported routes with limited exposure to avalanche terrain.
Discussion
Snow and Avalanche Discussion
The recent few inches of snow buried a mix of surface facets and surface hoar on shaded slopes, and melt freeze crusts on southerlies. On Saturday, observers reported a ski triggered D1.5 (just about big enough to injure, bury, or kill a person) that ran on a 40 degree Northeast aspect at 6,500ft. It was approximately 8" deep, and the propagation suggests the failure layer may be a persistent grain type. Conditions may begin to become more reactive as snowfall accumulates overnight.Â
Be mindful of loose dry avalanches as they may run fast and far within cohesionless upper layers out of the wind zone.Â
Significant snowpack variability can be found throughout the East-North zone. In outlying shallow snowpack areas further east of Washington Pass such as Goat Mountain and Twisp River, observers have reported particularly poor snowpack structure recently, even below treeline. Facets over a crust, and a layer of buried surface hoar have been observed.Â
Snowpack Discussion
February 19th, 2019
Recap
Weâre now over a week out from a major winter storm and avalanche cycle that left a string of school cancellations and avalanche near misses in its wake. As with snowfall amounts, the avalanche cycles have been similar, but not identical in all regions. The further weâre getting from the peak of the cycle, the more variation in avalanche conditions weâre seeing between regions and even within individual zones. Variable snow totals from storms this week are further adding to the range of conditions you will encounter. In some places, these storms may add stress to existing weak layers.
In the days after the natural cycle, it was obvious that you could trigger an avalanche. Large crowns were visible and you could feel and hear collapses in many zones. Managing your risk was easy. Avoid avalanche terrain. Since the natural avalanche cycle quieted down, the main concern for avalanches has focussed on the February 8th facets in regions where the weak layer is problematic.
A natural persistent slab (D2) on a north aspect at 4200 ft low in Glacier Creek drainage (Hwy 542). 02/13/19 Lee Lazzara Photo
Variability and Mixed Messages
As the time moves on and the snowpack structure changes, weâre seeing the potential for triggering avalanches change as well. The February 8th layer is rounding (strengthening) and the likelihood of triggering an avalanche on it is decreasing. So much so that the problem is trending to unlikely in some regions. Unfortunately, the consequences (size and destructive potential) remain the same if you do trigger an avalanche on this layer.
These conditions are commonly described as "low probability - high consequence" scenarios. Under these circumstances, common clues may paint a conflicting picture and snowpack tests become even more difficult to interpret (snowpack tests often donât give us a clear âgo or no-goâ answer, if such a thing exists).
Q: How do we manage our risk when observations are contradictory and difficult to interpret?
A: When avalanche conditions are complicated, defer to less consequential and simpler. Prioritize obvious clues, like recent avalanches, shooting cracks, or collapses. Focus on other observations that indicate a potential to trigger avalanches. Snowpack tests are just one piece of the decision-making puzzle. Lean on them as reasons to reduce your groups' exposure to avalanche terrain. Donât use them to justify traveling in more consequential terrain.
A natural persistent slab avalanche (D2), likely occurred on 2/12 on southwest through southeast aspects of Windy Mountain at 5,400ft in the Tye River drainage. Photo: Dan Veenhuizen.
Case Study
On the 17th I dug a profile, east of Stevens Pass on a north-northeast aspect at 4,127ft. I found the February 8th facets (0.5-1.5mm) rounding and buried 59cm from the surface. After much investigation, I found the following results at the February 8th interface: CTH (SP), ECTN28, PST 45/100 (END), 5 yellow flags (structural indicators). Later that day, about 2000 linear feet away from the profile site at the same elevation and slightly different aspect, we experienced a massive rumbling collapse.
All this crypto snow-speak means that some of the observations I made indicated that triggering an avalanche was likely, but some did not. Depending on your interpretation, some results could be argued either way. Confusing, right?
With all of this data in my field book, it was the collapse that stuck out. It was enough evidence for me to avoid slopes steeper than 35 degrees. That was a more obvious answer than all the other data I gathered and itâs the easiest to interpret. Without the collapse, I would have prioritized the test results that indicated I could have triggered a slide.
Avalanche Problems
Wind Slabs
Snowfall and winds are adding to the avalanche danger. The new snow is falling on melt freeze crusts on southerly aspects, and weak faceted snow on northerly aspects. The danger from avalanches within the new snow should be greater in the alpine due to stronger winds. If there is enough cohesion within the new snow layers, slab avalanches may be sensitive, easy to initiate, and they could pack a punch. Be especially cautious near ridges and where the wind has created thicker drifts. Out of the wind zone, the new snow may be susceptible to easy "sluffing", or loose dry avalanching on steep slopes. These could entrain, and run fairly fast. Cracking in front of your sled, or ski tips is a good sign to step back, and seek out lower angled and more sheltered terrain. Slides within the upper layers may step down and create much wider persistent slab avalanches.
Release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.
Wind Slabs form in specific areas, and are confined to lee and cross-loaded terrain features. They can be avoided by sticking to sheltered or wind-scoured areas..
Wind Slab avalanche. Winds blew from left to right. The area above the ridge has been scoured, and the snow drifted into a wind slab on the slope below.
Wind slabs can take up to a week to stabilize. They are confined to lee and cross-loaded terrain features and can be avoided by sticking to sheltered or wind scoured areas.
Aspects: All aspects.
Elevations: Alpine, Treeline.
Likelihood: Possible
Expected Size: 1 - 1
Persistent Slabs
In some areas, one to two feet of recent snow rests on weak faceted grains. The shallower snowpack zones further east, or closer to the Columbia River, have a more defined weak structure than the Washington Pass vicinity. Here, facets over a crust may be found even on shaded aspects, and a layer of buried surface hoar has been observed. The recent slide on a Northeast aspect at 6,500ft suggests a persistent grain type near the pass as well. Look for and test these layers with snowpack tests. Avoid freshly drifted areas, as any wind slab in the upper snowpack could step down and slide on deeper layers. Minimize your exposure to slopes that can produce consequential avalanches. Especially steer clear of steeper, unsupported slopes on shaded aspects. Stop and re-group in safer terrain, well out from even small, steep slopes.
Release of a cohesive layer of soft to hard snow (a slab) in the middle to upper snowpack, when the bond to an underlying persistent weak layer breaks. Persistent layers include: surface hoar, depth hoar, near-surface facets, or faceted snow. Persistent weak layers can continue to produce avalanches for days, weeks or even months, making them especially dangerous and tricky. As additional snow and wind events build a thicker slab on top of the persistent weak layer, this avalanche problem may develop into a Deep Persistent Slabs.
The best ways to manage the risk from Persistent Slabs is to make conservative terrain choices. They can be triggered by light loads and weeks after the last storm. The slabs often propagate in surprising and unpredictable ways. This makes this problem difficult to predict and manage and requires a wide safety buffer to handle the uncertainty.
This Persistent Slab was triggered remotely, failed on a layer of faceted snow in the middle of the snowpack, and crossed several terrain features.
Persistent slabs can be triggered by light loads and weeks after the last storm. You can trigger them remotely and they often propagate across and beyond terrain features that would otherwise confine wind and storm slabs. Give yourself a wide safety buffer to handle the uncertainty.
Aspects: All aspects.
Elevations: All elevations.
Likelihood: Possible
Expected Size: 1 - 1