Dashboard Regions Weather Stations Radar Alerts Glossary
Contact About
Log In

Register for an account and never miss a forecast again!

Register

Avalanche Forecast

Archived

Mar 13th, 2018–Mar 14th, 2018

Alpine
Natural avalanches unlikely, human triggered possible.
Treeline
Natural avalanches unlikely, human triggered possible.
Below Treeline
Natural avalanches unlikely.
Alpine
Natural avalanches unlikely, human triggered possible.
Treeline
Natural avalanches unlikely, human triggered possible.
Below Treeline
Natural avalanches unlikely.

Regions

.

A refreezing snowpack will cause decreased danger Wednesday in most areas. A Cornice failure could trigger a large wind slab or a Persistent Slab avalanche. Limit your exposure to overhead hazard Wednesday, staying away from large avalanche paths. Watch for fresh but shallow new Wind Slabs near ridges at higher elevations.

Detailed Forecast

A strengthening surface crust will limit the avalanche danger Wednesday. Shallow new snow may be transported near ridges, especially near and above treeline, where small wind slabs may be possible to trigger on steep lee slopes. Avoid steep open slopes showing signs of recent wind loading.

Older wind slabs have been stabilizing but you are most likely to find and trigger lingering wind slabs on shaded slopes above treeline where wind deposited snow Thursday and Friday. Use visual clues such as fresh cornices and snow drifts to identify and avoid wind loaded slopes.

Persistent slabs continue to exist along the East slopes of the Cascades. The exact depth and type of persistent weak layer depends on location. These present a low likelihood-high consequence scenario that resulted in three fatalities last weekend (3/3-3/4). Just because you see tracks on a slope does not mean it is safe. To avoid persistent slabs, stay off of large open slopes where these larger avalanches may occur. While these avalanches may be difficult for a person to trigger, a small avalanche such as a loose wet or cornice fall may trigger these deeper layers. 

Limit your exposure to overhead cornices as you travel. They may fail without warning due to daytime heating and the sun.

Snowpack Discussion

Sunshine and temperatures in the 40's to 50's over the past few days has allowed for significant snowpack settlement and for a variety of surface conditions to develop. Several melt-freeze cycles over the past few days has allowed for a strengthening snowpack. Steep shaded north facing slopes are hanging on to some settled old snow that fell Thursday.

Clear weather over the past few nights has allowed for surface hoar or near surface faceted snow to develop on many slopes. These surfaces are easily destroyed by wind, sun, warming or rain, so may end up being widely variable when future snowfall occurs. Precipitation falling Tuesday afternoon has begun as rain in most areas and hopefully destroyed much of these weak surface crystals.

Weak persistent layers exist within the snowpack. In the past two weeks three avalanche fatalities have occurred because of persistent slabs. The exact persistent weak layer and depth is dependent on location.Generally 6-14" of new snow fell along the east slopes of the Cascades Thursday through Thursday night, with lesser amounts further east. Strong winds transported snow forming wind slabs and other wind-affected snow surfaces. This resulted in several wind slab avalanches being reported from the Washington Pass area Friday and Saturday. 

Three commonly seen persistent weak layers are:

  • Surface hoar and facets buried on 3/8. This layer is generally found near and below treeline just below the recent strom snow.
  • On slopes that received direct sun, a thin facet-sun crust can be found. This layer is generally 1-2 feet below the snow surface.
  • A more wide spread persistent weak layer is found just above a firm crust layer buried on 2/5. This layer of weak sugary facets (2/13) can be found 2-4 feet below the snow surface.
  • Other shallow and very weak snowpacks may be found further east of the crest or in areas with less snow.

Observations

North

On Monday, North Cascade Heli reported two very small wind slabs, one triggered and one natural on steep shaded slopes at 6000 and 7000 feet.

On Friday and Saturday, North Cascade Heli reported several slab avalanches near and above treeline. These avalanches occurred on a variety of aspects and were up to size D2.

On Thursday during the storm, NCMG generally found the 2/5 crust down 30-35" in the Hairpin valley with a 0.5 cm layer of 1.5 mm rounding facets. They did not see the Feb 23 facets, but found a layer of 5 mm surface hoar buried on March 8th down 3-12" due to variable wind transport. Wind slabs were reactive on N-E-S aspects. 

Mid-week, observers reported a mix of sun crusts and surface hoar/near surface facets prior to snow on 3/8.

Central

On Friday, Mission Ridge Pro Patrol reported 2" of new snow with extremely high winds forming slabs that were not reactive on test slopes or column tests. The recent 2" of snow sits on a layer of 3-4 mm surface hoar buried 3/8. The 2/5 crust was down 20" and was still reactive in snowpack tests.

Problems

Persistent Slabs

Persistent Slab avalanches are the release of a cohesive layer of snow (a slab) in the middle to upper snowpack, when the bond to an underlying persistent weak layer breaks. Persistent layers include: surface hoar, depth hoar, near-surface facets, or faceted snow. Persistent weak layers can continue to produce avalanches for days, weeks or even months, making them especially dangerous and tricky. As additional snow and wind events build a thicker slab on top of the persistent weak layer, this avalanche problem may develop into a Deep Persistent Slab.

Wind Slabs

Wind Slab avalanches are the release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.