Register
Get forecast notifications
Create an account to receive email notifications when forecasts are published.
Login
Archived

Avalanche Forecast

Feb 23rd, 2020–Feb 24th, 2020
Alpine
3: Considerable
The avalanche danger rating in the alpine will be considerable
Treeline
3: Considerable
The avalanche danger rating at treeline will be considerable
Below Treeline
2: Moderate
The avalanche danger rating below treeline will be moderate
Alpine
3: Considerable
The avalanche danger rating in the alpine will be considerable
Treeline
3: Considerable
The avalanche danger rating at treeline will be considerable
Below Treeline
2: Moderate
The avalanche danger rating below treeline will be moderate

Regions: Snoqualmie Pass.

Even though the storm will draw to a close Monday, don’t let your guard down. This may not be your standard northwest storm cycle, and avalanches may act in surprising ways. You could trigger an avalanche on open slopes greater than 30 degrees at mid and upper elevations. 

Discussion

Stormy conditions should diminish over the course of the day Monday. Consequently, you should experience the greatest avalanche danger in the morning.  However, don’t look for the avalanche danger to drop too quickly. In some areas, the storm snow fell on weak snow surfaces including sugary facets and feathery surface hoar. This could cause any slab avalanche to remain reactive and fail in surprising ways. You could remotely trigger slides, see wide avalanches, or find they occur low on the slope. In the Alpental Valley Saturday, mild temperatures and a bit of drizzle seemed to breakdown this weak snow. In other parts of the zone that may not have been the case. We’re particularly worried about buried weak snow grains east of the Hyak exit, above 4000’, and at upper elevations around the Alpental Valley. NWAC staff on Mt Margaret Sunday easily triggered small avalanches on test slopes on W-NW-E aspects. Despite their thin crowns, some avalanches entrained snow and ran further than expected. Stormy conditions made identifying the weak layer extremely difficult, however, facets were found in nearby snow profiles.

A small avalanche on a test slope. W aspect 5300’. Small facets were found near the crust in a nearby snow profile. Photo: Dallas Glass

Snowpack Discussion

February 20, 2020 (The regional synopsis is updated every Thursday @ 6 pm)

Intermittent Storms

January’s non-stop pattern of storms extended into the first week of February. Since then, we’ve transitioned to more intermittent storms with notable stretches of high pressure and dry weather. We now see more variability through the region in the snowpack layering and avalanche conditions than in January. 

Significant periods of calm weather in February have allowed avalanche danger to decrease between storms. During the clear periods, strengthening late winter sun and gradual warming has brought some loose wet avalanche cycles to sunny slopes. Even so, from February 1st-20th there were 10 days when one or more zones were forecasted at all Low danger. In comparison, the month of January had zero days with any zone forecasted at all Low avalanche danger. 

Surface hoar near Snoqualmie Pass. February 19th. Photo: Ely Gerbin

Looking Forward

As we look forward, there are a number of considerations that are pertinent to most zones. The pattern of storms separated by clear periods may form new weak layers and interfaces to monitor. Many zones hold variable surfaces that warrant consideration as a travel hazard. In the Mt Hood Meadows area, two fatalities were related to falls on slick surfaces over President’s Day weekend. Another important consideration is the cornice growth that occurred in the past month from predominantly west winds. Very large cornices loom on ridges in most zones, except for possibly the Olympic Mountains. Future warming could be the added ingredient needed for cornices to fall. A close call with a cornice-triggered avalanche near White Pass on February 12th is a reminder of the potential hazard that cornices can pose. 

 

A party of three triggered this avalanche from below on a southeast aspect at 5400ft near Skyline Lake, Stevens Pass on February 16th. Two members of the party were fully buried and one was partially buried. The party self-rescued and no injuries were sustained. Photo: Dustin Riggs 

Weak Layers

So far this season, we’ve had limited persistent weak layers to deal with. February’s periods of calm weather developed a couple of weak layers and problematic interfaces that later got buried in the snowpack. On a whole, weak layers have been short-lived and have generally resolved within a couple of days of being buried. While the following weak layers are no longer major concerns, some readers may want a more in-depth understanding of them before venturing into the mountains.

In the Stevens Pass and East Central zones, the February 4th interface consisted of a thin layer of small (0.5-1.0mm) facets sitting on the stout February 1st melt forms (crust). The crust was widespread on all aspects up to at least 7500ft and the facets were most prominent on the northern half of the compass (west through north through east aspects). A major storm and avalanche cycle February 4th-7th totaled over 60 inches of snow. The February 4th interface was responsible for widespread avalanching including slides up to size D3 at most elevations. As direct action avalanches subsided, the February 4th interface was deeply buried and didn’t produce further triggered avalanches. Interestingly, as recent as February 18th, this interface was found in a profile and produced some mixed and head-scratching test results. While this interface is not a concern for triggered avalanches, you may still be able to find it 4-6 feet below the surface, especially on sheltered, shaded slopes at upper elevations.

 

A profile from 6460ft on a northeast aspect in the Chiwaukum Range on February 18th shows the February 4th layer. Small column tests produced sudden planar results while a Propagation Saw Test did not indicate propagation.

A more elusive and problematic layer for triggered avalanches was the February 13th interface. This was also most prominent in the Stevens Pass and East Central zones in addition areas of the West Central and Snoqualmie Pass zones. At Stevens Pass a combination of large (2.0-4.0mm) surface hoar and small (0.5mm) near-surface facets developed on a variety of surfaces and were buried on the 13th. The weak layer was most problematic on east through south aspects between 4,500-6,000ft, where the grains were preserved as they rested on a thin crust. It seemed that outside of this aspect and elevation range either 1) the weak grains did not persist enough to be triggered by travelers or 2) the underlying layer, or bed surface, wasn’t hard enough for the weak layer to be reactive. A number of parties reported natural and triggered avalanches on southeast aspects during the storm cycle on Presidents Day weekend. This included a party of three that were uninjured after all being caught, with two full-burials, in a surprising avalanche near Skyline Lake on the 17th. As of February 20th, the interface is 1-3 feet below the surface and has become difficult to trigger. The February 13th interface is still visible in the snowpack and we continue to monitor it. It will likely become inactive before the end of the month.

In summary, February has been a great time to explore the mountains and enjoy the longer days for recreating in this season’s robust snowpack. Though, not without complexity and variability. Continue to monitor changing conditions and check the daily avalanche forecasts for the most up to date information. 

Avalanche Problems

Wind Slabs

This storm has been incredibly windy for the Snoqualmie Pass zone, particularly at mid and upper elevations. Wind slabs were prevalent in several locations Sunday and we only expect them to be larger and more widespread on Monday.  Look for wind slabs on the lee sides of ridges and along the sides of exposed mid-slope features. Clues, such as drifts, textured snow surfaces, and cornices can point you to where wind slabs may exist in the landscape. Take time to identify and avoid steep wind loaded slopes.

Release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.

 

Wind Slabs form in specific areas, and are confined to lee and cross-loaded terrain features. They can be avoided by sticking to sheltered or wind-scoured areas..

 

Wind Slab avalanche. Winds blew from left to right. The area above the ridge has been scoured, and the snow drifted into a wind slab on the slope below.

 

Wind slabs can take up to a week to stabilize. They are confined to lee and cross-loaded terrain features and can be avoided by sticking to sheltered or wind scoured areas.

Aspects: All aspects.

Elevations: Alpine, Treeline.

Likelihood: Likely

Expected Size: 1 - 1

Storm Slabs

Remember, in some locations, the new snow may not behave like normal northwest storm slabs. This could be a good time to choose conservative terrain and put a little extra space between you any open slopes greater than 30 degrees. Storm slabs may be the easier to trigger and larger above about 4000’. Small slope tests and simple hand pits can give you an indication of how the storm snow may respond. At lower elevations, the storm snow appears to have bonded well to the old surface making it harder to trigger an avalanche. 

If you see sustained sun breaks in the afternoon, start thinking about changing conditions including loose wet avalanches. These could occur naturally from steep sunny slopes where shedding snow may trigger fan-shaped avalanches. Don’t let yourself get surprised by these easy to anticipate events.

Release of a soft cohesive layer (a slab) of new snow that breaks within the storm snow or on the old snow surface. Storm-slab problems typically last between a few hours and few days. Storm-slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.

 

You can reduce your risk from Storm Slabs by waiting a day or two after a storm before venturing into steep terrain. Storm slabs are most dangerous on slopes with terrain traps, such as timber, gullies, over cliffs, or terrain features that make it difficult for a rider to escape off the side.

 

Storm slabs usually stabilize within a few days, and release at or below the trigger point. They exist throughout the terrain, and can be avoided by waiting for the storm snow to stabilize.

Elevations: Treeline, Below Treeline.

Likelihood: Likely

Expected Size: 1 - 1