Avalanche Forecast
Regions: Cascades - North East.
Look for thickened wind slab as you transition into wind affected areas, especially near ridgelines and below cliff outcrops. Daytime warming will further destabilize upper snow layers and may result in loose wet avalanches. Avoid steep slopes when you find signs of recent fan shaped avalanches, or wet snow surfaces.
Discussion
On Wednesday observers found about 6" of new snow at 5,000ft, with over 10" above 6,000ft near Washington Pass. They were able to trigger small loose dry avalanches in steep features, and noted plumes indicating wind drifting snow from high peaks. Expect warmer temperatures for Thursday, with less wind. Cornices are large and may continue to fall, especially with warmer temperatures and some sun in the forecast. Take time to assess how recent layers are bonding in the upper few feet of the snowpack if venturing into higher elevation terrain.Â
Â
Snowpack Discussion
February 27, 2020 (The regional synopsis is updated every Thursday @ 6 pm)
In the lead up to last weekend, dry, clear and cold conditions produced surface hoar in many areas as well as faceted snow (check out the National Avalanche Center’s encyclopedia for more details). These weak grain types were not difficult to find and recreationists and professionals across the region began to wonder what role these weak snow surfaces would play when the next storm arrived.
Surface Hoar was not difficult to observe during this period of high pressure. This picture is from 2/21 on an SSE aspect, 5,000’ at Stevens Pass just a day before it may have been buried. Photo: Josh Hirshberg
We didn’t have to wait too long, as a major storm arrived on Sunday 2/23, creating dangerous avalanche conditions for most zones. This system dropped close to 2’ of snow at Mt. Baker while areas to the south along the west slopes of the Cascades saw closer to 1 foot. Areas along the east slopes of the Cascades also saw significant new snow amounts with Blewett Pass and Mission Ridge receiving around 6-8†of fresh snow.Â
The wind was also a major factor with this storm from about Stevens Pass southward. Multiple stations recorded winds over 80mph and some went over 100mph. This wind was enough to strip surfaces down to old crusts on windward aspects, leaving leeward aspects with wind slabs and touchy cornices. In the case of Mt. Hood, relentless winds this season have stripped the snow down to blue ice from one of our previous atmospheric river events, creating slide for life conditions on certain slopes.Â
The old snow interface, termed 2/22 for the day it was buried, has us thinking hard about the snowpack moving forward. In the northern part of the region, less wind allowed for more storm than wind slabs, with avalanches that released on both interstorm layers and on the buried 2/22 interface for a day or two following the storm. As you moved further southward or eastward, reactivity on the 2/22 interface was trending downward or non-existent after a natural avalanche cycle that immediately followed the storm. Was the storm potent enough to wipe out the surface hoar and facets? There was a surprising natural avalanche on Stevens Pass during the evening of Monday 2/24, which is suspected to have run on small facets. This avalanche and continued snowpack observations around the region proves that in specific areas, reactive weak snow still existed.Â
This natural avalanche failed 2ft deep on the 2/22 interface on a SE aspect near 5700ft on Cowboy Mountain. 02/25/20. Photo: Stevens Pass Ski Patrol
On Tuesday, the sun started to shine in some locations, bringing back the threat of wet avalanches and again making us wonder about how warming would affect the 2/22 interface. We never reached the tipping point for widespread wet avalanche activity, but rollerballs and snow shedding off trees and rocks were certainly present in many zones. Drizzle or light snow made an appearance on Wednesday along many west-side zones. Thursday saw a return to warm temperatures and sunny skies all the way from Mt. Hood to Stevens Pass with cooler and cloudier conditions for the North Cascades. All in all, it was a quiet week avalanche-wise and the 2/22 wasn't activated.Â
We have one more dry mild day before we move into a stormy Saturday. During this stretch, we’ll continue to monitor buried weak snow grains for distribution and reactivity. Check your local forecast zone for the latest.Â
Avalanche Problems
Wind Slabs
Expect to find cohesive wind slab over a variety of old surfaces. Use caution as you enter wind exposed slopes, near ridgelines and open terrain. Look for wind textured, punchy, or hollow sounding snow. You may find larger and thicker slabs the higher you go, and these could fail on weak, older snow up to 2ft deep. Use small, inconsequential test slopes to check how these slabs are bonding. These slabs may become more difficult to trigger as time goes on, but caution is still warranted around them. If you see signs of instability like shooting cracks or hear whumphing, avoid wind affected slopes 35 and steeper.
Release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.
Wind Slabs form in specific areas, and are confined to lee and cross-loaded terrain features. They can be avoided by sticking to sheltered or wind-scoured areas..
Wind Slab avalanche. Winds blew from left to right. The area above the ridge has been scoured, and the snow drifted into a wind slab on the slope below.
Wind slabs can take up to a week to stabilize. They are confined to lee and cross-loaded terrain features and can be avoided by sticking to sheltered or wind scoured areas.
Aspects: All aspects.
Elevations: Alpine, Treeline.
Likelihood: Possible
Expected Size: 1 - 1
Loose Wet
Sun and mild temperatures will begin to destabilize the snow as the daytime warms. Expect these to occur first on east aspects, then move to south and southwest by mid day. More snow is available to entrain at mid and upper elevations, so slides may become larger if they start up there. Rollerballs and sticky snow surfaces are clues that you may be able to trigger loose slides. Take these as a sign that it's time to move off those slopes.
Release of wet unconsolidated snow or slush. These avalanches typically occur within layers of wet snow near the surface of the snowpack, but they may quickly gouge into lower snowpack layers. Like Loose Dry avalanches, they start at a point and entrain snow as they move downhill, forming a fan-shaped avalanche. They generally move slowly, but can contain enough mass to cause significant damage to trees, cars or buildings. Other names for loose-wet avalanches include point-release avalanches or sluffs. Loose Wet avalanches can trigger slab avalanches that break into deeper snow layers.
Travel when the snow surface is colder and stronger. Plan your trips to avoid crossing on or under very steep slopes in the afternoon. Move to colder, shadier slopes once the snow surface turns slushly. Avoid steep, sunlit slopes above terrain traps, cliffs areas and long sustained steep pitches.
Several loose wet avalanches, and lots of pinwheels and roller balls.
Loose wet avalanches occur where water is running through the snowpack, and release at or below the trigger point. Avoid terrain traps such as cliffs, gullies, or tree wells. Exit avalanche terrain when you see pinwheels, roller balls, a slushy surface, or during rain-on-snow events.
Aspects: East, South East, South, South West, West.
Elevations: All elevations.
Likelihood: Possible
Expected Size: 1 - 1