Avalanche Forecast
Regions: Mt Hood.
Recently formed wind slabs have become more stubborn and less likely to trigger above treeline. In very steep terrain on shady aspects, don’t let loose dry avalanches that can run fast and far catch you off guard. Looking ahead, dangerous avalanche conditions are expected to develop Friday night.
Discussion
Snow and Avalanche Discussion
A sharp increase in the avalanche danger is expected Saturday due to an increase in snow and wind Friday night and Saturday. Stay tuned and check the forecast before heading into avalanche terrain over the weekend.Â
The Mt Hood area picked up about 8 inches of very light, dry snow Sunday night through Tuesday morning. Strong alpine winds from the NW redistributed snow above treeline Wednesday, scouring some areas down to the previous firm rain crust and creating fresh shallow wind slabs in other areas. Small but fast-moving loose dry avalanches are possible on very steep slopes. Cold temperatures will continue to preserve the low density surface snow on any slope not wind affected or receiving direct sunshine.Â
Snowpack Discussion
February 5, 2019
The active weather pattern this past weekend brought most areas a shot of new snow. Sadly, it seems like areas close to Seattle may have gotten more snow than the mountains. As a result, we are generally finding lower avalanche danger in most of our forecast zones. The general exception to this rule is the mountains closest to the Canadian border. The Baker area received 4â of water since January 31st. Here are a few general trends we see at this point.
The surface is where itâs at:
A combination of high elevation rains in January, a week of warm high pressure, and minimal new snow loads allowed most of our snowpacks to gain strength. In many locations, we are finding that proverbial Cascade âbrick.â Itâs not that you canât find any weak snow in the mid- and lower snowpacks, but as a general rule, the snowpacks in our forecast regions are strong. Consequently, most unstable snow will be limited to the snow surface and the last interface buried in the most recent storm. For example, this week observers are primarily tracking the snow surface and the interface buried on February 1st or 3rd, depending on your location.
Very strong surface snow. This crust was buried in most locations Feb 1 or 3. Photo: Chip Daly
How can you use this? Keep your eyes open as you travel and look for areas that appear different. Why are they different? Could this be a rogue wind slab? Is the sun affecting the snow in this location more than other areas? Is the snowpack thinner and weaker in this area? When you find unique areas, it may be worth giving them a wide berth.
Still watching the far-east:
There is a lingering exception⦠areas east of highway 97 and east-slopes nearer to the Columbia River. As you travel further east in our forecast area, the snowpack gets thinner, weaker, and more variable. So, why are we seeing the avalanche danger go down in these locations? In general, there just isnât a substantial slab over the buried weak layers. Two things could change that. 1. A wind event. One quick way to get a slab is to build one with some dry snow and moderate winds. Thatâs why we have wind affected areas on our mind when we travel to areas with thinner snowpacks. 2. A big storm. While areas like the Wenatchee mountains have seen their fair share of snow this season, these areas havenât seen a big loading event. How would this weak snowpack handle a big storm? Itâs hard to say at the moment. Just remember, if you go to mountainous areas around Twisp, the Wenatchee Mountains, or the East-South zone, you may encounter snowpacks with lingering persistent weak layers.
A shovel tilt test highlights weak snow interfaces in a very shallow east-side snowpack. Photo: Josh Hirshberg
The danger is real:
Even though the snowpack is strong and the avalanche hazard is generally low, there are other risks in the mountains that may pose a very real danger to backcountry travelers. The one we keep hearing the most about is very firm and slick surfaces. You are most likely to find icy surfaces in locations that did not receive much snow during this recent storm. When conditions are like this, itâs tough to gain traction, and any slip may result in a long uncontrolled fall.
Icy snow surfaces have been making travel conditions difficult, and sometimes dangerous. This firm, slick layer is buried below the most recent snow in many locations. Photo: Dallas Glass
Whatâs next?:
Given the strength of the snowpack, it will likely take a larger storm to ramp the avalanche danger back up. When will that storm arrive? Weâll keep watching the weather patterns and let you know. Make sure to check the latest weather and avalanche forecast before you head into the mountains.
-NWAC team
Avalanche Problems
Wind Slabs
Recently formed wind slabs may linger on unusual aspects Friday due to recent NW winds redistributing low density surface snow. As you travel higher on the mountain, keep your eyes peeled for wind affected surfaces including deep drifts and wind-scoured surfaces. Approach steep unsupported slopes with wind-drifted snow cautiously, testing for firm or hollow sounding snow as a sign that wind slabs may be present. You can stay safe by traveling on ridges, wind-scoured areas and any slope less than 35 degrees.
Release of a cohesive layer of snow (a slab) formed by the wind. Wind typically transports snow from the upwind sides of terrain features and deposits snow on the downwind side. Wind slabs are often smooth and rounded and sometimes sound hollow, and can range from soft to hard. Wind slabs that form over a persistent weak layer (surface hoar, depth hoar, or near-surface facets) may be termed Persistent Slabs or may develop into Persistent Slabs.
Wind Slabs form in specific areas, and are confined to lee and cross-loaded terrain features. They can be avoided by sticking to sheltered or wind-scoured areas..
Wind Slab avalanche. Winds blew from left to right. The area above the ridge has been scoured, and the snow drifted into a wind slab on the slope below.
Wind slabs can take up to a week to stabilize. They are confined to lee and cross-loaded terrain features and can be avoided by sticking to sheltered or wind scoured areas.
Aspects: All aspects.
Elevations: Alpine.
Likelihood: Possible
Expected Size: 1 - 1